C3 cyclopolymerization. I. Is the cyclopolymerization of 1,3-bis(p-vinylphenyl)-propane by means of radical or anionic initiators possible?

Polymerization of 1,3-bis(p-vinylphenyl) propane (St-C₃-St) was investigated by using radical and anionic initiators. Radical polymerization yielded linear polymer with pendant styryl groups in pertinent conditions without gelation. Anionic polymerization with n-butyllithium and sodium naphthalene produced insoluble polymers that, according to infrared (IR) spectroscopy, had no cyclized units. On the other hand, phenylmagnesium bromide gave soluble polymer in HMPA-benzene mixed solvent. Zero-valent nickel catalyst also gave soluble polymer. The soluble polymers could be analyzed by several spectroscopies, and it was confirmed that those obtained by anionic and coordination polymerization had no [3.3]paracyclophane units in the main chain. From these results it was concluded that cationic propagation could be assumed if the polymer Of St-C₃-St contained [3.3]paracyclophane units in the main chain.     

Insoluble polystyrene-bound quaternary onium salt catalysts for the synthesis of cyclic carbonates by the reaction of oxiranes with carbon dioxide

The addition reaction of oxiranes ( 26a—e ) with carbon dioxide (CO₂) was performed using insoluble polystyrene beads containing pendant quaternary ammonium or phosphonium salts as catalysts under atmospheric pressure. The reaction of 26a—e with CO₂ proceeded smoothly catalyzed by 1–2 mol % of the polymer-supported quaternary onium salts to give the corresponding cyclic carbonates ( 27a—e ) in high yields at 80–90°C. In this reaction system, the catalytic activity of the polymer-supported quaternary onium salts was strongly affected by the following factors: degree of ring substitution (DRS) of the onium salt residues to the polymer, degree of crosslinking (DC) of the polystyrene beads, chain length of the alkylene spacer between the polymer back-bone and the onium salt, hydrophobicity of the alkyl group on the onium salts, and kind of onium salts. That is, the polymer-supported quaternary phosphonium salts with low DRS and DC and with long alkylene spacer chain were found to have higher catalytic activity than low molecualr weight quaternary onium salts. The above polymer-supported catalysts can easily be separated at the end of a reaction by filtration and can be reused for at least seven runs. It was also found that the rate of reaction was proportional to the products of catalyst concentration and oxirane concentration. © 1993 John Wiley & Sons, Inc.     

High-Pressure Synthesis and Crystal Structure of B2S3

Two new high-pressure phases of binary boron-sulfur compounds, B₂S₃-II and B₂S₃-III, were synthesized at 3-6.2 GPa. A single crystal of B₂S₃-III was grown and the structure was determined (tetragonal, space group I4₁/a, a=16.086(2) Å, c=30.488(4) Å; V=7888(1) ų, Z=100, R=3.0% and R_w=2.8% for 3047 observed data [I>3.00σ(I)]. The structure of B₂S₃-III consists of two kinds of macrotetrahedra built up from 20 and 34 BS₄-tetrahedra. These macrotetrahedra connect each other to form an interpenetrating zincblende-type structure by sharing BS₄-tetrahedra at the corners of those. B₂S₃-III is anticipated having a rather disordered structure. From the UV-Vis diffuse reflectance spectrum, the optical band gap of B₂S₃-III was estimated to be 3.7 eV.     

Synthesis,surface accumulation,and micellar properties of amphiphilic block copolymers

Amphiphilic block copolymers, i.e., poly(methyl methacrylate)-b-poly(2-dimethylethylammoniumethyl methacrylate), were synthesized by the reaction between two prepolymers. Carboxyl-terminated poly(methyl methacrylate) and hydroxyl-terminated poly(2-dimethylaminoethyl methacrylate) were prepared by radical polymerization of the corresponding monomers in the presence of thioglycolic acid and 2-mercaptoethanol as a chain transfer agent, respectively. Two condensation methods, i.e., DCC and the acid chloride method, were used for the reactions of these prepolymers. The subsequent quarternization produced the amphiphilic block copolymers. Surface property of poly(methyl methacrylate) films containing this amphiphilic block copolymer was examined by measuring contact angles for water. The addition of only 0.5 wt% of the block copolymer was sufficient to make poly(methyl methacrylate) surfaces hydrophilic. The block copolymer formed a polymeric micelle in acetone–water mixed solvent.     

Efficient photocleavage of DNA by cationic porphyrin-acridine hybrids with the effective length of diamino alkyl linkage

Positively charged porphyrins bearing an acridine with various lengths of diamino alkyl linkage, 5-[4-[(6-chloro-2-methoxy-9-acridyl)aminoalkylaminocarbonyl]phenyl]-10,15,20-tris(4-N-methylpyridiniumyl)porphine triiodide, alkyl=ethyl, butyl, hexyl, or octyl, were synthesized. They exhibited more enhanced photocleavage activity of pUC18 plasmid DNA than TMPyP, meso-tetrakis(4-N-methylpyridiniumyl)porphine, which is well known to bind to DNA tightly and to cleave DNA effectively; the hybrid linked with the hexamethylene chain showed particularly high activity. An equilibrium dialysis experiment demonstrated that the binding ability of the hybrids to calf thymus (CT) DNA correlated quantitatively with the photocleavage activity. The lack of the substantial red-shift of the Soret maxima of the hybrids through the titration with CTDNA denied the intercalative binding of the porphyrin part. In their circular dichroism (CD) spectral change on binding to CTDNA, two negative peaks appeared at 275 nm and at 285-290 nm in the UV range. The latter negative peak was observed for hybrids, but not for TMPyP, and thus we assigned it to induced CD (ICD) derived from intercalation of acridine chromophore. In the visible range, the hybrids showed only a positive peak around their Soret maxima, and this feature suggested the porphyrin moiety lay in the DNA groove. In addition, the length of the linker markedly influenced the ellipticity of their visible ICD, suggesting that the proximity of the porphyrin moiety to DNA was greatly affected by the linker.     

Radiation-induced emission from golden hamster embryo cells

Emission from high-energy-electron-irradiated golden hamster embryo (GHE) cells has been studied over the temperature range 12–300 K both by a one-shot-single-photon-counting method and by photocurrent measurements with an oscilloscope. Emission from the irradiated phosphate buffered saline (PBS) also has been studied. The emission spectra from PBS at 12 and 77 K show a maximum around 330 and 380 nm, respectively, which are the same spectra as those from irradiated pure H₂O. The emission from irradiated GHE consists of the new band at 480 nm in addition to the emission from H₂O. The 480 nm emission is observed at the temperature range of 12–300 K, though the emission at 300 K is much lower than that at low temperature. The 480 nm emission is ascribed to the transition from excited organic substances in GHE cells. The intensity of 480 nm emission at 300 K increases linearly with increasing irradiation-dose in the range of 11–600 Gy.     

Protonation-induced structural change of lyotropic liquid crystals in oley- and alkyldimethylamine oxides/water systems

Lyotropic phase behavior of the nonionic and the half-ionized oleyldimethylamine oxide (OlDMAO)/water systems was investigated using polarized light microscopy, small-angle X-ray diffraction, and differential scanning calorimetry. Nonionic OlDMAO formed isotropic micellar solution, nematic, hexagonal, cubic, and lamellar liquid crystalline phases as the surfactant concentration increased. In contrast, half-ionized OlDMAO (i.e., 1:1 mixture of the nonionic and the protonated species) had a greater tendency to form bilayer structures, and the phase diagram became quite similar to those of double-chained ionic surfactants rather than single-chained ones, despite the introduction of positive charges to the nonionic one. The preference of the bilayer structures in the half-ionized OlDMAO was interpreted in terms of the dimers stabilized by the hydrogen bond between the nonionic and protonated species. For alkyldimethylamine oxides with a saturated hydrocarbon chain (CnDMAO, chain length: n = 14, 16, and 18), the phase sequence of lyotropic liquid crystals was hardly affected by the protonation, but an elongation of the cylinders of the hexagonal phase was observed for the half-ionized C14DMAO. Consequently, it can be considered that the dominant bilayer formation of the half-ionized OlDMAO is attributed to the combined effect of the hydrogen-bonded dimer formation and the cis-double-bond configuration of the alkyl chain.     

Rheology of polystyrene solutions around the coil overlapping concentration: A phenomenological description of stresses in simple shear flow

Linear viscoelasticity behavior is described with the sum of two terms for polystyrene solutions in tricresyl phosphate around the coil overlapping concentration (K. Osaki, T. Inoue, & T. Uematsu, J Polym Sci Part B: Polym Phys 2001, 39, 211). One is a Rouse–Zimm (RZ) term represented by the Zimm theory with arbitrarily chosen values of the hydrodynamic interaction parameter and the longest relaxation time (τ_RZ). The other (the L term) consists of a relaxation mode with a single relaxation time (τ_L > τ_RZ) and a high‐frequency limiting modulus proportional to the square of the concentration. In this study, we describe the viscosity (η) and first normal stress coefficient (Ψ₁) in steady shear with simple formulas. The stress due to the L term is assumed to be given by a Kaye, Bernstein, Kearsley, and Zapas (K‐BKZ) equation with the damping function h(γ) = (1 + 0.2γ²)^?1/2, where γ is the magnitude of shear. Contributions to η and Ψ₁ from the RZ term are derived from the RZ model, in which the relaxation time in steady flow is given by τ_st = τ + (τ_RZ ? τ)/(1 + 0.35τ_RZ γ˙) instead of τ_RZ. Here, γ˙ is the rate of shear, and τ is the τ_RZ value at the infinite dilution limit. η and Ψ₁ at various concentrations for two polystyrene samples (with molecular weights of 2890 and 8420 kg mol^?1) are well described with parameters derived from dynamic viscoelasticity. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 1038–1045, 2002     

Application of 1,2,3,5,6,7-hexahydropyrrolizinium perchlorate in the synthesis of 7a-substituted hexahydro-1h-pyrrolizines

The method for preparing 7a-substituted hexahydro-1H-pyrrolizines 2 from 1,2,3,5,6,7-hexahydropyrrol-izinium Perchlorate (3) was investigated, by which introduction of a wide variety of functionalities on C(7a) could be achieved easily.     

Stereochemistry and mechanism of catalytic hydrogenation of substituted cyclohexanones

Substituted alkylcyclohexanones were hydrogenated over several transition metal catalysts. The hydrogenation with freshly prepared Raney Ni gave predominantly the axial alcohols but catalyst to which sodium hydroxide was added or aged catalyst increased the stereoselectivity. In contrast to the PtO₂ hydrogenation in which the equatorial alcohols were favoured, more axial alcohols were obtained than the equatorial counterparts on Pt-black. On Pd catalyst the isomeric ratios of the cyclohexanols changed as the reaction progressed. This may be due to a decrease in the amount of hydrogen available caused by the strong adsorption of ketones on the catalyst. Rh catalyst gave more of the axial alcohols than any other catalyst used in the present study.